Cytron SmartDriveDuo-30

We know DC brushed motor is widely used for many different applications; from conveyor, AGV (Automated Guide Vehicle), mobile robot and combat robot. One of the reasons is the ease to use it, just connect the two terminals of motor to power respectively, it will start rotating, so simple. Yet, to control the speed and direction from a controller, a motor driver is needed.  This is SmartDriveDuo-30, with the ease of accepting RC ( Radio Control ) signal to drive two DC brushed motors in independent or mix mode, it is perfect for combat robot. Not to forget it supports up to 80Amps of peak current (1 second) and 30Amps continuous current at each channel, best for medium power motor. And with that, it is smart enough to accept control signal from: RC (Radio Control) PWM of microcontroller Analog voltage of Potentiometer/Variable Resistor/Joystick UART data of microcontroller The operation mode is determined by the configuration on DIP switch, please do refer the  User's Manual  for detailed settings. Not to forget, to make it RC receiver friendly, we have added 2x3 header pin, with just 2 x  RC extension cable (which is included), the wiring is done, it takes only 2 minutes! And by default, MDDS30 is configured in RC controller, Mixed control mode, even easier! With MDDS30's wide operating voltage range, you can now series up two  SLA battery  to power your motor as it supports up to  35VDC  input. And you only require one power input to operate the motor and driver. Don't worry, 3-cell and 6-cell  Li-po battery  are within the operating voltage :) Hey! It also comes with battery low voltage warning, what else do you need? Which motor is good to be driven by MDDS30? As long as the motor: Is DC Brush motor (Two Terminals) Operating voltage from 7V to 35VDC Rated Current